eduroam on-boarding for iOS Devices(CAT)

This is a Guide to on-boarding your iOS device(iPad/iPhone) using the eduroam CAT tool.  

Please note this is not preferred method for installing eduroam.  For the preferred method, please follow: https://support.lesley.edu/en/support/solutions/articles/4000185609-eduroam-on-boarding-for-ios-devices-clearpass-

1. Connect your device to the Internet.  If you are off-campus or using cellular data, proceed to step 5.  Otherwise proceed to step 2.

2.  On campus, you may connect your device to the "Lesley WiFi" network for the purpose of installing eduroam. 

3. Once connected, you should see the following pop-up browser; however, The eduroam installer will not work in iOS's pop-up browser, therefore press cancel on the upper right. 

4. Click on Use Without Internet so you don't get disconnected from the Lesley WiFi network.

5. Open Safari web browser and go to "https://livelesley-my.sharepoint.com/:u:/g/personal/matthew_perry_lesley_edu/EQHzZRSDMg1LnjgOCexQNm4B_VXlE5lUKNCdhxhCjUISTA?e=NQTW2q" or "https://tinyurl.com/bp52yuj2"

6. Press Download to download the profile.

7. Press Allow in order to download the configuration

8. Press Close when the download finishes

9. Now that you have the profile downloaded go to you devices settings and click on "Profile Downloaded"

10. Click on the "eduroam Lesley University" profile

11. Press Install 

12. Press Next

13. Press Install

14. Press Install

15. Enter you Lesley Email Address making sure you have the @lesley.edu to the end.  Then press Next

16. Enter you Password and then press Next

17. Press Done

18. Now go to your Wi-Fi setting and select eduroam to connect to it.

After installing eduroam, please insure that Proxy has been disabled in your WiFi settings as described in the article https://support.lesley.edu/support/solutions/articles/4000177999-disabling-ios-proxy-setting