Using the MiPro Personal PA

Using Personal PA 

Getting Started

• Once you have the MiPro speaker out, turn the power switch on. (Power switch Is a dial Labeled: (Power/Mic VOL) 
• Plug in AC adapter into the power port and then into the wall

Using Aux Audio

• Connect the aux cord to the input labeled: (LINE IN)
• Connect the aux cord to the headphone port on your laptop or computer
• Turn the LINE VOL to the desired volume

Using the Wireless Mic (Two can only be used at time)

• Once you have the mic out of the PA bag, you want to insert the batteries. Batteries can be located in the PA bag
• To insert the batteries, unscrew the bottom of the mic and insert them.
•  Flip the switch on the front of the mic to power it on.
• When the mic is powered on you will see the corresponding channel illuminate. If the mic isn’t connecting to a channel, then it will need to be re-synced. Read the “syncing the microphones” section.
• Turn the volume up and down on the channel with the dial located on the PA.

Syncing the Microphones ONLY if mics aren’t syncing to the channel on the PA. 

• Make sure the mic is powered on. Do not remove the batteries
• There is a red sensor located on the back of the mic, hold the red senor up to the desired channel on the PA, either channel 1 or channel 2
• Press the “scan/act” button on the PA channel and wait 3 secs
• “RF” indicator will show you which channel you are on, then you may adjust the volume on the channel

Turning off the PA

• Turn the power all the way to the left. It will click off.

                                                                              Information Technology

815 Somerville Ave, 2^nd Floor | Cambridge, MA 02138 | it@lesley.edu |617-349-8770